Neff C44L20N3GB - Manual (Page 15)

15
‹‹ : ‹‹ lights up in the display Power cut Reset the time of day (see section: Setting
the clock)
The appliance is not in operation. x
appears in the display, and a cooking time
The … button was not pressed after set-
ting
Press the … button to start, or press the
~ main switch to turn off the appliance
The appliance is not in operation. The time
of day is not shown in the display.
The clock display is switched off Switch on the clock display (see section:
Changing the time of day; switching the
clock display on and off)
The Î (Fill water tank) indicator appears,
even though the water tank is full
The water tank has not been inserted
properly
Slide in the water tank until it engages.
The detection system is not working Descale the appliance (see section: Des-
caling) and check which water hardness
has been set (see section: Setting the
water hardness range)
It is difficult to engage the water tank Rubber seal on the water tank valve Lightly grease the rubber seal with lubri-
cant (order no. 311 168)
The evaporator dish has boiled empty
even though the water tank is full.
The water tank has not been inserted
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance (see section: Des-
caling).
Check whether the water hardness range
is set correctly
The evaporator dish is overflowing The evaporator dish was not emptied after
the last cooking operation
Use the enclosed cleaning sponge to
empty the evaporator dish after every
cooking operation
Extremely loud pumping sound during
cooking
Water tank is empty, but water is still evap-
orating in the evaporator dish
Filling the water tank
The water tank has not been inserted
properly
Slide in the water tank until it engages
Pumping sound during cooking This is normal
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam.
This is normal
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal (see section: Automatic cali-
bration)
When cooking with steam, a lot of steam is
created again
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Restore the appliance to factory settings
(see section: Basic settings) and recali-
brate the appliance (see section: Before
first use)
Steam escapes from the ventilation slots
during cooking
This is normal
The appliance is not producing steam
properly
Limescale has formed in the appliance Start the descaling programme.
Hose for the water inlet in the cooking
compartment was pushed to the side or
has hooked itself to the side of the cook-
ing compartment wall.
Strong pressure on the hose or hooking of
objects when cleaning
Call after-sales service and do not use the
appliance.
Cooking compartment light has failed The LED lamp is defective Contact the after-sales service. The glass
light cover cannot be removed
An “ ... error message appears in the dis-
play
Technical fault. Press the KJ clock function button to
delete the error message, and reset the
clock if necessary.
If the error message appears again, call
the after-sales service
The error message “‹‚‚ appears in the
display
A button was pressed for too long or is
jammed
Press the KJ clock function button to
delete the error message
Press all of the buttons individually and
check if they are clean
The appliance is not heating. The colon
flashes in the display
A button combination was activated Press and hold the o button for
4 seconds, then press the Í button
Problem Possible cause Notes/remedy