Neff C44L20N3GB - Manual (Page 14)

14
The descaling operation consists of:
■
Descale (approx. 30 minutes), then refill the water tank and
empty the evaporator dish
■
1st rinse (30 seconds) and then empty the evaporator dish
■
2nd rinse (30 seconds) and then remove the remaining water
All three steps must be completed in full. The appliance is
ready for operation again only after the 2nd rinse.
Descaler
Only use the liquid descaler recommended by customer
service for descaling (product no. 311 138, also available
online from the eShop). Other descalers may damage the
appliance.
Observe the cleaning agent manufacturer's instructions.
1. Prepare a descaling solution by mixing 300 ml water and
60 ml liquid descaler.
2. Empty the water tank and fill with descaling solution.
3. Carefully slide in the water tank with the descaling solution
and close the appliance door.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Caution!
Damage to the appliance: If descaler is in the appliance for a
prolonged period, this may damage the water pump. Ensure
that the descaling and rinsing cycles take no longer than three
hours to complete.
Starting descaling
The cooking compartment must have cooled down completely.
1. Press the ~ main switch to turn on the appliance.
2. Press the Í button.
The Î symbol (Fill water tank) is displayed. This is to remind
you to fill the water tank with the descaling solution (see
section: Descaler).
3. Press the … button.
1st rinse
A signal sounds after approx. 30 minutes. The
Î symbol (Fill
water tank) and x ‚ : ‹‹ min are displayed.
1. Rinse the water tank thoroughly, fill with water until the MIN
mark and reinsert.
The
Ì symbol (empty evaporator dish) appears.
2. Remove the descaling solution from the evaporator dish
using the cleaning sponge supplied.
3. Close the appliance door and press the … button.
The appliance starts rinsing.
2nd rinse
After a short time, the
Ì symbol appears again. x ‹ : „‹ min
appears in the display.
1. Thoroughly rinse out the cleaning sponge.
2. Remove the remaining water from the evaporator dish using
the cleaning sponge.
3. Close the appliance door and press the … button.
The appliance starts rinsing.
Once descaling is complete,
‹‹ : ‹‹ and Ì appear in the
display.
4. Press the ~ main switch to finish descaling and switch off
the appliance.
Removing the remaining water
Remove the remaining water from the evaporator dish using the
cleaning sponge. Wipe out the cooking compartment using the
cleaning sponge and then dry with a soft cloth.
Cancelling the descaling
Note: After cancelling the descaling, you must rinse the
appliance twice. Other applications are disabled until the
second rinsing operation is complete.
Press and hold the
… button to cancel the descaling process.
To ensure that no descaling solution remains in the appliance,
it must be rinsed twice after a cancellation.
The
Î symbol appears.
Now proceed as described in the "1st rinse" section.
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
:
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Problem Possible cause Notes/remedy
The appliance does not work The plug is not plugged in. Connect the appliance to the electricity
supply
Power cut Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box to make sure that
the fuse for the appliance is OK
Faulty operation Switch the appliance off using the fuse in
the fuse box. Wait approximately
10 seconds and then switch it back on
The appliance cannot be started The appliance door is not fully closed Close the appliance door.
Appliance does not start. x and ‚ : ‹‹
min appear in the display
Descaling has been cancelled Rinse the appliance twice
(see section: Cancelling descaling)