Brother HL-1850 - Manual (Page 42)

38
The Tape margin function allows you to adjust the size of the margins on the left and right
sides of your text.
The default tape margin setting is FULL; however, three other settings are also available.
☞
After printing using the NARROW and HALF tape margin settings, push down on the
tape cutter lever to cut off the label, and then use scissors to cut along the cutting guide
(:) to centre the text within the label.
To change the tape margin setting:
1 Rotate + until 09/18 TAPE is displayed, and then press + to display the current
tape margin setting.
2 Rotate + until the desired tape margin setting is displayed, and then press + to
apply it to the entire text.
OR
1
While holding down c, press E once, and keep c held down to display the
current tape margin setting.
2 While still holding down c, continue pressing E until the desired tape margin
setting is displayed.
3 Release c to apply the selected tape margin setting to the entire text.
FULL (24 mm margins)
NONE (2 mm margins)
NARROW (4 mm margins)
HALF (12 mm margins)
TAPE MARGIN FUNCTION