Nokia 3620 - Manual (Page 48)

[ 39 ]
Settings
If access points are defined, to create a new access point, select
Options → New access point and select:
• Use default settings to use the default settings. Make the needed
changes and press Back to save the settings.
• Use existing settings to use existing setting information as the basis
for the new access point settings. A list of existing access points is
opened. Select one and press
OK . Access point settings are opened
with some fields already filled.
Delete an access point
In the list of access points, scroll to the access point you want to remove
and select
Options → Delete .
Edit an access point
When you open Access points, the list of already available access points
opens. Scroll to the access point you want to edit, and press
.
Options when editing access point settings are: Change , Advanced
settings , Help , and Exit .
Here you can see a short explanation for every setting that may be needed
for different data connections and access points.
Note: Start entering settings on Connection name and go down
the list from there because depending on which data connection
you select (
Data bearer ) or whether you need to insert a Gateway
IP address , only certain setting fields are available.
Note: Follow the instructions given to you by your service provider
very carefully.
Connection name —Give a descriptive name for the connection.
Data bearer —The options are GSM data , High speed GSM , and GPRS .
Depending on what data connection you select, only certain setting fields
are available. Fill in all fields marked with
Must be defined , or marked
with a red asterisk. Other fields can be left empty, unless you have been
instructed otherwise by your service provider.