Nokia 3620 - Manual (Page 34)

[ 25 ]
Your phone
Swap is used to switch between the active call and the call on hold.
Transfer is used to connect an incoming call or a call on hold with an active
call and to disconnect yourself from both calls.
Send touch tones is used to send touch tone strings, for example, passwords
or bank account numbers.
1 Key in the digits with the 0–9 keys.
Each keystroke generates a touch tone, which is transmitted while the
call is active. Press the * key repeatedly to produce: *, p (inserts a pause
of about two seconds before, or between touch tone characters.), and w
(if you use this character, the remaining sequence is not sent until you
press
Send again during the call). Press the # key to produce #.
2 To send the tone, press OK .
You can also store a sequence of touch tones for a contact card. When
you make a call to the contact, you can retrieve the sequence. Add touch
tones to the phone number or
Touch tone fields in a contact card.
Note: Touch tones are the tones you hear when you press the number
keys on the phone keypad. Touch tones allow you to communicate
with voice mailboxes and computerized telephony systems.
Settings for call forwarding
When call forwarding is activated, you can direct your incoming calls to
another number, for example, to your voice mailbox number. For details,
contact your service provider.
Go to Menu
→
Tools
→
Forward .
• Select one of the forward options, for example, select If busy to
forward voice calls when your number is busy or when you decline
incoming calls.
• Select Options → Activate to set the forward setting on, Cancel to set
the forward setting off, or Check status to check whether the forward
is activated or not.
• To cancel all active forwards, select Options → Cancel all forwards .