Nokia 3620 - Manual (Page 44)

[ 35 ]
Settings
Call waiting (system service)
The system will notify you of a new incoming call while you have a call
in progress. Select
Activate to request the system to activate call waiting,
Cancel to request the system to deactivate call waiting, or Check status
to check if the function is active or not.
Automatic redial
When this setting is activated, your phone will make a maximum of ten
attempts to connect the call after an unsuccessful call attempt.
Press
to stop automatic redialing.
Summary after call
Activate this setting if you want the phone to briefly display the duration
and cost of the last call. To show costs, the
Call cost limit must be activated
for your SIM card.
1-touch dialing
Select On , and the numbers assigned to the 1-touch dialing keys (2–9)
can be dialed by pressing and holding the key.
Anykey answer
Select On , and you can answer an incoming call by briefly pressing any
key except , , and .
Line in use (system service)
This setting is shown only if the SIM card supports two subscriber numbers,
that is, two phone lines. Select which phone line (
Line 1 or Line 2 ) you
want to use for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
Note: You will not be able to make calls if you select Line 2 and
have not subscribed to this system service.
To prevent line selection, select Line change → Disable if supported by
your SIM card. To change this setting, you need the PIN2 code.
To switch between the phone lines, press and hold the # key in the
standby mode.