Toshiba Slim Port Replicator III - Manual (Page 7)

User’s Manual EN-7
Slim Port Replicator III
Quick Tour
This section identifies the various components of the Slim Port Replicator III.
Front View
Figure 1-1 shows the Slim Port Replicator III’s front side.
Figure 1-1 The front side of the Slim Port Replicator III
Power Switch
Computer Connector
Docking LED
Eject Button
Guide Pin
Hooks
Guide Pin
Power Switch Turns the docked computer’s power on and off.
Pressing the power switch has no effect if a computer is not connected to
the Slim Port Replicator III.
NOTE
Computer
Connector
Connects to the computer’s docking port.
Hooks Secure the computer to the Slim Port Replicator
III.
Guide Pins Engage holes on the bottom of the computer to
ensure a proper connection.
Docking LED Glows blue during normal operation. Turns off
when the computer completes its disconnect
sequence.
Eject Button Begins the computer’s disconnect sequence.
When the docking LED goes out it is safe to
disconnect the computer.
Once the Eject button is pressed, the dock stops working. Redock before
using the Slim Port Replicator III again.
NOTE