Toshiba DR20 - Manual (Page 32)

32 EN
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during One-touch Timer
Recording, press [REC I] repeatedly until the desired
length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP C].
8
Press [STOP C] to stop the recording.
This operation may take a few moments to complete.
Note
• You can change the channel while in the REC pause mode.
• Recording continues until the disc is full or you stop the
recording.
• If the clock is not set, the date and time of title names will be
01/01/09 and 00:00.
• You cannot change the recording mode in the REC or REC
pause mode.
• Even if the broadcasting you are recording is in the SECAM
system, this unit automatically converts it to the PAL system
when recording.
• Up to 99 titles can be recorded on the DVD-RW/-R discs.
• Up to 49 titles can be recorded on the DVD+RW/+R discs.
• NTSC recording is prohibited in this unit.
• The remaining recording time will appear on the TV screen
during One-touch Timer Recording. Press [DISPLAY] to see
it on the TV screen.
• The remaining recording time will be displayed on the front
panel display during One-touch Timer Recording.
• Unlike the timer recording, you can perform the following
operations during One-touch Timer Recording.
- Turn off the power. (One-touch timer recording will be
cancelled.)
- Use [REC I] or [STOP C] on the remote control.
• You cannot use the pause function during One-touch Timer
Recording.
• The unit will be turned off automatically under the following
conditions.
- No space remains on the disc.
- If a power failure occurs.
Timer Recording
You can set the unit to record up to 12 programmes, up to a
month in advance. Daily or weekly programme recordings are
also available.
• Be sure to set the clock before entering a timer
programming.
Insert a recordable disc.
1
In stop mode, press [TIMER PROG.].
“Timer Programming” list will appear.
2
Select “New Programme” using [K \ L], then
press [ENTER
\OK].
• If there are 6 programmes or more, use
[SKIP H \ G] to turn the page.
3
Enter the date using [K \ L], then press [1].
Each time you press [L] at the current date, the timer
recording date will change as follows.
e.g., 1st January
• Analogue channel is indicated as “ATV”.
4
Enter the time to start and to end using [K
\ L],
then press [1].
DVB ANALOG
DVD-RW DVD-RW DVD-RW
Video
DVD-RW DVD-RW DVD-RW
VR
DVD-R DVD-R DVD-R DVD+RW DVD+RW DVD+RW DVD+R DVD+R DVD+R
1/1
17/05 0:00
20/05
21/05
7:00
9:00
9:00
9:30
DVB 18
DVB 190
Timer Programming
Date Start End CH STTL
PDC
MON
New Programme
01/01
Daily
M-F (Mon.-Fri.)
W-SAT
W-FRI
W-SUN
31/01
Timer Programming
1/1
0:00 MON 17/05
New Program
Date
CH Mode STTL
Start End
20/05
DVB 10 SP OFF
--:-- --:--
SP 2:00
E7TE0BD_EN.book Page 32 Friday, March 5, 2010 5:08 PM