Toshiba NB200 User Manual
Page 92
User’s Manual
8-4
Optional Devices
Installing a memory module
To install a memory module:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
section in Chapter 3,
if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove one screw securing the
memory module cover.
■
Use only memory modules approved by TOSHIBA.
■
Do not try to install or remove a memory module under the following
conditions.
a. The computer is turned on.
b. The computer was shut down in either Suspend or Hibernation
Mode.
c. Wake-up on LAN is enabled.
d. The wireless communication is enabled.
■
Be careful not to let screws or other foreign matter fall into the
computer. It could cause malfunction or electric shock.
■
Additional memory modules are precision electronic components that
may be fatally damaged by static electricity. Since the human body can
carry static electricity, it is important that you discharge yourself before
touching or installing any additional memory modules. To discharge
your body’s static electricity, simply touch any metal close to you with
bare hands.
■
Turn off the power and disconnect the AC adaptor when installing or
replacing a memory module.
■
If you use the computer for an extended period of time, the memory
modules and the circuits located close to the memory modules will
become hot. Allow then to cool to room temperature before you
replace them.