Toshiba Magnia 3310 - Manual (Page 75)

Setup
After Installation (Windows 2000)
71
After Installation (Windows 2000)
If you have finished Windows 2000 installation, then follow the
steps below:
Confirming and Setting up the Time Zone
1 Start Windows 2000 and log on as Administrator (or a user
having equivalent rights).
2 Run Date/Time Properties by clicking Start, Settings,
Control panel, and double clicking on Date/Time.
3 Click Time Zone tab.
4 Check that the current Time Zone setting is correct. If
incorrect, select the correct setting and press [OK].
Installing the Windows 2000 Service Pack
If you do not perform a quick installation of the Windows 2000
Service Pack, you have to install it manually for attached devices
and installed software to work correctly.
Setting up the Physical Address Extension
To set up the Physical Address Extension, refer to your MAGNIA
3310 User's Guide.You only need to do this if you have more than
4GB of System Memory installed.
Setting up the SAF-TE Controller
Make the following setting only when the hard disk drive is
connected to the onboard SCSI controller. For details on how to
setup the SAF-TE controller, refer to the MAGNIA3310 User’s
Guide.