Toshiba Magnia 3310 User Manual

Page 102

Hardware Diagnostics
Items of Hardware Diagnostics

SCSI ID NUMBER

This option sets the SCSI ID to test. You can specify just one ID to
test except ID:7.

CHANNEL NUMBER

If the server has multiple SCSI channels, this option sets the
channel number to test.

[01. Sequential address read]

This subtest is a sequential reading of all the blocks on the
HDD, starting at block 0.

[02. Connection]

This subtest reads the logical sector at the end of the HDD, and
then recognizes if the drive is connected or not.

NOTE: The [01. Sequential address read] tests all areas of
the hard disk drive. If the capacities of installed hard disk
drives are large enough, the test may take a few hours.
If you do not know where the hard disk drives are connected
(host ID, SCSI ID and channel number of the SCSI
controller), you can find them from [01. INQUIRY] of [09.
SCSI TEST].

SCSI HDD TEST (HDD)

Status

Error name

Meaning

CHECK CONDITION OR BAD
COMAND

Bad command error

DRIVE SELECTION FAILED

ID selection error

TARGET DRIVE BUSY

The target drive is busy

SCSI BUS TIME OUT

Time out error of SCSI bus

DMA BOUNDARY ERROR

DMA BOUNDARY occurred

COMMAND TERMINATED

A command terminated

QUEUE FULL

Command queue is full

NO SENSE

The sense data is invalid

RECOVERED ERROR

The execution of the command has correctly
finished because of recovery treatment