Toshiba Magnia 3310 - Manual (Page 73)

Setup
After Installation (Windows Server 2003)
69
After Installation (Windows Server 2003)
If you have finished Windows Server 2003 installation, then
follow the steps below:
Confirming and Setting up the Time Zone
1 Start Windows Server 2003 and log on as Administrator (or a
user having equivalent rights).
2 Run Date/Time Properties by clicking Start, Settings,
Control panel, and double clicking on Date/Time.
3 Click Time Zone tab.
4 Check that the current Time Zone setting is correct. If
incorrect, select the correct setting and press [OK].
Setting up the Physical Address Extension
To set up the Physical Address Extension, refer to your MAGNIA
3310 User's Guide. You only need to do this if you have more than
4GB of System Memory installed.
Setting up the Active Directory (To make this server
as a domain controller)
If you installed the TCP/IP protocol and you want to designate this
server as a domain controller in your network, you must install
Active Directory.
For more information about Active Directory, refer to the
Windows Server 2003 Help.