Toshiba Satellite U200 - Manual (Page 61)

User’s Manual 3-9
Getting Started
2. While holding down the palm rest with one hand so that the main body
is not raised, lift the panel slowly. Adjust the angle of the panel to
provide optimal clarity.
Opening the LCD display panel
Turning on the power
This section describes how to turn on the power.
1. Open the computer’s LCD display panel.
2. Press and hold the computer’s power button for two or three seconds.
Turning on the power
Be careful not to open the display panel too far as this could put stress on
the display panel’s hinges and cause damage.
Use reasonable care when opening and closing the LCD display panel.
Opening it vigorously or slamming it shut could damage the computer.
Display latch
LCD display panel
■ After you turn on the power for the first time, do not turn it off until you
have set up the operating system. Refer to the section Starting up for
the first time .
■ If the USB floppy disk drive is connected, make sure it is empty. If a
floppy disk is in the drive, press the eject button and remove the floppy
disk.
Power button