Toshiba Satellite U200 - Manual (Page 160)

8-14 User’s Manual
Optional Devices
11. Replace the memory module cover and screw in the two screws.
Replace the memory module cover
12. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
13. Screw the two screws and secure the keyboard.
14. Set the keyboard brace into its groove and press down to secure the
latches.
15. Install the battery pack. Refer to the Replacing the battery pack section
in Chapter 6, Power and Power-Up Modes , for details.
16. Turn your computer over.
17. Turn the power on and make sure the added memory is recognized.
Click start, click Control Panel, click Performance and Maintenance
and select the System icon. Open System Properties window and
click General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Set the computer to boot mode and turn the computer’s power off.
Make sure the Power indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
the Replacing the battery pack section in Chapter 6, Power and Power-
Up Modes , for details.
4. Follow steps 4 through 9 in Installing memory module to remove the
memory module cover.
5. Push the latches to the outside to release the module. A spring will
force one end of the module up.
Screws
Memory module cover
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found.