Toshiba Satellite U200 - Manual (Page 122)

6-4 User’s Manual
Power and Power-Up Modes
Do not change the battery pack while the AC adaptor is connected.
Before you remove the battery pack, save your data and shut down the
computer, or set the computer to Hibernation Mode. While entering
Hibernation Mode, the computer saves the contents of memory to the hard
disk drive. However, for safety sake, it is best to save your data manually.
To ensure that the battery pack maintains its maximum capacity, operate
the computer on battery power at least once a month until the battery pack
is fully discharged. Refer to Extending battery life in this chapter for
procedures. If the computer is continuously operated on AC power through
an AC adaptor for an extended period, more than a month, the battery may
fail to retain a charge. It may not function efficiently over the expected life of
the battery and the Battery indicator may not indicate a low-battery
condition.
Using a battery pack other than one supplied or specified by TOSHIBA
(PA3356U) for this PC would interfere with the computer’s display when
open and could damage the LCD display panel.
■ The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
■ Always use the battery pack supplied as an accessory or an equivalent
battery pack specified in the User’s Manual. Other battery packs have
different voltage and terminal polarities. Use of non-conforming battery
packs could generate smoke or cause fire or rupture, possibly resulting
in serious injury.
■ Always dispose of used battery packs in compliance with all applicable
laws and regulations. Put insulating tape, such as cellophane tape, on
the electrode during transportation to avoid a possible short circuit, fire
or electric shock. Failure to do so could possibly result in serious injury.
■ Do not remove the battery pack while the computer is in Standby Mode.
Data is stored in RAM, so if the computer loses power it will be lost.
When the computer is powered off in Standby Mode, and the AC
adaptor is not connected, the battery pack supplies power to maintain
data and programs in memory. If the battery pack is completely
discharged, Standby Mode will not function and the computer loses all
data in memory.