Brother 1030e - Manual (Page 21)

Setup 15
B
ASIC USE
Custom Settings
Volume Settings
Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The machine comes set to LOW. When the beeper
is set to LOW or HIGH, the machine beeps every time you press a key or make an error, and at the
end of sending or receiving a fax.
1
Press Menu/Set, 1, 3.
2
Press or to select your setting.
3
When the screen displays the setting you want, press Menu/Set.
4
Press Stop/Exit.
Speaker Volume
You can adjust the speaker volume. If you have FAX-1020e, you must lift the handset, then press
Tel before you can adjust the volume. If you have FAX-1030e, press Speaker phone.
Press or to adjust the volume level. The screen displays the setting you are choosing. Each
key press changes the volume to the next setting. The new setting will remain until you change it
again.
■ When you enter your name, see Entering Text, page 91.
■ The telephone number you enter is used only for the Call Back Message and
Cover Page features.
■ If you do not enter a fax number, no additional information can be entered.
■ To enter a space, press
once between numbers and twice between
characters.
■ If your Station ID has already been programmed, the screen prompts “1” to
make a change, or “2” to exit without changing.
If you have FAX-1030e, you can adjust the speaker volume while you are listening
to your OGM (Outgoing Message) and ICMs (incoming messages).
If you turn Incoming Recording Monitor to OFF (Menu/Set, 8, 5) on FAX-1030e,
the Speaker for screening calls will be disabled and you won’t hear callers leaving
messages. The volume for other operations can still be controlled using
and
.