Pioneer DJM-T1 - Manual (Page 26)

26 En
Setting the source of audio data output from
this unit to the computer
Display the setting utility before starting.
1 Click the [MIXER OUTPUT] tab.
2 Click the [Mixer Audio Output] pull-down menu.
Select and set the audio data to be output to the computer from the flow of audio
signals inside this unit.
USB 1/2 USB 3/4 USB 5/6
CH1 Timecode PHONO 1 CH2 Timecode PHONO 1 Post CH1 Fader
CH1 Timecode CD 1 CH2 Timecode CD 1 Post CH2 Fader
— — Cross Fader A
— — Cross Fader B
— — MIC/AUX Post EQ
— — REC OUT
1 : The sound output from [USB 1/2] and [USB 3/4] is output with the same volume
as input to this unit, regardless of the [USB Output Level] setting.
3 Click the [USB Output Level] pull-down menu.
Adjust the volume of the audio data output from [USB 5/6].
! If not enough volume can be achieved with the DJ software’s volume adjustment
alone, change the [USB Output Level] setting to adjust the volume of the audio
data output from this unit. Note that the sound will be distorted if the volume is
raised too high.
Setting the MIDI channel
Display the setting utility before starting.
1 Click the [MIDI] tab.
2 Click the [MIDI CHANNEL] pull-down menu.
Select the desired MIDI channel.
Adjusting the buffer size (when using Windows
ASIO)
If an application using this unit as the default audio device (DJ software, etc.) is run-
ning, quit that application before adjusting the buffer size.
Display the setting utility before starting.
Click the [ASIO] tab.
! If the buffer size is made large, drops in audio data (breaks in the sound)
occur less easily, but the time lag due to the delay in the transfer of the audio
data (latency) increases.
Checking the version of the driver software
Display the setting utility before starting.
Click the [About] tab.
Checking the latest information on the driver
software
For the latest information on the driver software for exclusive use with this unit, visit
our website shown below.
http://www.prodjnet.com/support/
! Operation cannot be guaranteed when multiple units of this mixer are con-
nected to a single computer.