Pioneer HTP-710 - Manual (Page 21)

Speaker Setup (HTP-610) 01
21
En
English
Deutsch
Italiano
Español
Français
Nederlands
2 (When mounting center speakers to right
and left) Stack the speakers and fix with the
bracket.
Each speaker is provided with a color-coded
indicator on the model label on the rear side to
assist identification. Refer to the color
indicators and install the speakers correctly.
As shown in the illustration, stack the
speakers. Align the bracket with the respective
upper and lower screw holes as shown in each
figure below and fasten the screws securely.
CAUTION
• Do not attempt to carry the speakers when
they are connected with the bracket. Doing
so may cause damage to the bracket or
worsen damage to the bracket and
speakers in the event they are dropped.
3 Connect each speaker.
Connect the wires to the speaker. Each
speaker in the illustration can be identified by
means of the color-coded indicator provided
on the rear-surface label.
Front left: White
Front right: Red
Center: Green
Surround left: Blue
Surround right: Gray
Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the other
wire into the black (–) side.
• When connecting the center speakers,
connect the Y-cable dual end to the two
center speakers in the same way.
Model label
Color indicator
Left Right
Green
Center
speaker
Front
speaker
Green
White Red
Bracket
Screw
Center
speaker
Front
speaker
Black (–) Red (+)
Color-coded wire
Y-cable
To receiver subwoofer
HTP-710_VYXCN_En.book 21 ページ ２０１０年８月２３日 月曜日 午後６時４７分