Resetting the microprocessor, Before you start – Pioneer AXM-P90RS User Manual
Page 5

! If you need to operate this unit while driving,
look ahead carefully to avoid being involved in
a traffic accident.
! Do not leave this steering remote control free
(unattached). When stopping the car or turn-
ing, the unit might drop on the floor. If the unit
rolls under the brake pedal, it might prevent
the driver from braking properly, causing ser-
ious problems. Be sure to fix the steering re-
mote control to the steering wheel.
Card remote control
! Point the remote control in the direction of
the remote control sensor to operate.
! The remote control may not function prop-
erly in direct sunlight.
Steering remote control
! Key assignment can be changed by select-
ing the DIP switch.
DIP switch
! Key assignment conversion chart
1
2
3
4
5
6
8
7
DIP
switch
1-3
1-4
2-3
2-4
1
c
d
2
b
a
3
d
a
4
a
b
5
ATT
ATT
6
VOLUME (
–)
VOLUME (+)
DIP
switch
1-3
1-4
2-3
2-4
7
SOURCE
SOURCE
8
VOLUME (+)
VOLUME (
–)
! If DIP switch is selected to 1-3 or 2-3, the
steering remote control controls this unit.
! If DIP switch is selected to 1-4 or 2-4, this
steering remote control can be used as a
general purpose for Pioneer unit.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET with a pen tip or other
pointed instrument.
RESET button
Before You Start
En
5
Section
01
Before
Y
o
u
Start