Resetting the system – Pioneer SC-LX78-S User Manual
Page 87
87
Using other functions
09
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select ‘RESET’ using PRESET
k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting
Default
Digital Video Converter
OFF
SPEAKERS
TMd/FW ON
Speaker System
7.2.2ch TMd/FW
Speaker Setting
Front
SMALL
Center
SMALL
TMd/TFw/TBw
SMALL
FH/FW
SMALL
Surr
SMALL
SB
SMALLx2
SW
SW1+2 YES
Surround Position
ON SIDE
Crossover
80Hz
X-Curve
OFF
DIMMER
Medium bright
Inputs
See
Input function default and possible settings
on
.
Input Volume Absorber
All Inputs
0dB
HDMI
HDMI Audio
AMP
Control
OFF
Control Mode
--- (OFF)
ARC (Audio Return Channel)
--- (OFF)
PQLS
--- (AUTO)
Standby Through
OFF
4K/60p
4:4:4
DSP
Power On Level
LAST
Setting
Default
Volume Limit
OFF
Mute Level
FULL
Phase Control
ON
Auto Sound Retriever
iPod/USB, INTERNET RADIO, MEDIA
SERVER, FAVORITES, BT AUDIO input
function
ON
Other input functions
OFF
Sound Delay
0 ms
Dual Mono
CH1
DRC
OFF
LFE Attenuate
0dB
Auto delay
OFF
Digital Safety
OFF
Effect Level
ALC (Auto Level Control)
50
Center Spread
Input with video image
OFF
Input without video image
ON
Neo:X Options
Center Gain
Neo:X CINEMA: 1.0
Neo:X MUSIC: 0.3
Neo:X GAME: 1.0
All Inputs
Listening Mode (2 ch/multi ch)
AUTO SURROUND
Listening Mode (Headphones)
STEREO
See also
for other default DSP settings.
MCACC
MCACC Position Memory
M1. MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
3.00 m
Standing Wave (M1 to M6)
ATT of all channels/filters
0.0 dB
SWch Wide Trim
0.0 dB
EQ Data (M1 to M6)
All channels/bands
0.0 dB
EQ Wide Trim
0.0 dB
Network
Network Standby
OFF
DHCP
ON