Barco R9003110 - Manual (Page 49)

7. Main Menu
7. MAIN MENU
7.1 Autosetup
Introduction to Autosetup
Autosetup creates the best suited image file for the connected source.
Therefore Autosetup calculates/measures several parameters of the sources:
• Total pixels per line
• Start pixel
• Phase
• Contrast/Brightness levels
The measure of the total number of pixels per line can be done through 2 methods
• Limited scan: a windowing is used to allow fast tracking, takes about ...
• Full scan: tracking is done over the full range, takes about ...
How to setup the scan method ?
1. Press MENU to activate the Toolbar
2. Press → to select the Main item
3. Press ↓ to Pull down the Main menu
4. Use ↑ or ↓ to select Autosetup
5. Press → to pull down the menu (image 7-1)
6. Use ↓ or ↑ to select the desired method
7. Press ENTER
Image 7-1
R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004 45