AEG Voxtel R100 - Manual (Page 5)

5
UK
4 OPERATION
4.1 Turning the unit on/off
To turn on:
tPress and hold the power button
.
>A special “beep“ sound will be heard. The LCD screen will display the current channel.
To switch off:
tPress and hold the power button
.
>A special “beep“ sound will be heard and the LCD screen will turn blank.
4.2 Adjusting the speaker volume
There are 8 volume levels, the current speaker volume level is displayed on the LCD screen.
To adjust the speaker volume level:
tPress the up button to increase or press down button to decrease.
>The LCD screen will display the speaker volume icon bars ascending, or descending
respectively.
4.3 Receiving a call
The unit is continuously in receive mode when the unit is turned on and not transmitting.
When a signal is received on the current channel, the receive signal icon
will be
displayed on the LCD screen.
4.4 Transmitting (sending)
tPress and hold the PTT (Push to Talk) button to transmit your voice.
>The transmit signal icon will display on the LCD screen.
tHold the unit in a vertical position with the microphone 5 cm away from the mouth. While
holding the PTT button, speak into the microphone in a normal tone of voice.
tRelease the PTT button when you have finished transmitting.
Important:
tIn order for other people to receive your transmission, they must also be on the same
channel that you are currently using. Refer to the „4.6 Changing channels“ for more
information.
tWhen the PTT and/or call buttons are continuously pressed, your PMR cannot receive
any transmissions.
4.5 Roger beep
The roger beep is a tone which is automatically transmitted whenever the PTT button is
released. This alerts the receiving party that you have ended the transmission, and you are
now in receive mode.