Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-14674 - Manual (Page 18)

Using the lp utilities Using the lp Utilities for Solaris
Document name
–t
Replace the name of the specified file.
Finishing options - bind
-o bind=
Bind the document after it is printed. To use this option,
the selected printer must have a binder installed and
enabled.
Finishing options - stitch
-o staple | stitch=
Staple the document after it is printed. You can enter
“stitch” or “staple” to indicate that the document is to be
stapled. “Staple” is equivalent to stitch = singlePortrait.
The stitch option allows you to select the location of the
stitch or staple. The available options are: singlePortrait,
singleLandscape, dualLandscape, dualPortrait,
rightSinglePortrait, rightSingleLandscape, or
rightDualLandscape. The staple option default to a single
portrait stitch if no option is given. To use this option, the
selected printer must have a stitcher or stapler.
Finishing options – other finishing devices
–o finishing=
Specify an attached finishing device. The device name
must match the name defined by the System
Administrator on the DocuSP controller. See the Print
Service Operator for the list of defined device names.
Finishing options – no finishing
–o nofinishing
The no-finishing option would be used to override all
finishing selections other than those provided by the
overrides on the queue. Typically, this option would be
used when reprinting a job.
2-4