Konica Minolta PagePro 1350EN - Manual (Page 41)

Resetting the printer to factory defaults 34
Resetting the printer to factory defaults
If the printer was manually configured to an invalid IP address, or moved to a
different network, and communication cannot be established anymore, you
might have to reset it to factory settings to re-enable DHCP/BOOTP auto-
matic protocols. In such a case, please follow these steps:
1
Turn on your printer.
When the green “Ready” indicator is on, reset the printer to factory
default.
2
Make sure that
– the orange “Error” indicator is off.
– the green “Ready” indicator is on (but not blinking).
3
Press the cancel button for more than 20 seconds, until:
– the orange “Error” indicator and the green “Ready” indicator are slowly
blinking alternately (about 1 blink per second).
4
Press the cancel button one more time.
– the green “Ready” indicator blinks for a few seconds, then stops blink-
ing and remains on.
5
Restart the printer to use the new (factory) settings.