Konica Minolta PagePro 1350EN - Manual (Page 18)

Network Connection 11
Using PageScope Network Setup
You may also manually change the printer's IP address, subnet mask, and
gateway by using PageScope Network Setup.
1
Connect your printer to the network.
When using an Ethernet cable, plug the RJ45 connector into the Ethernet
interface port of the printer.
2
Turn on your PC and printer.
Wait until the green “Ready” indicator is on.
3
Insert the CD-ROM that shipped with your printer and install PageScope
Network Setup from the CD-ROM menus, by selecting PageScope Utili-
ties, PageScope Setup then PageScope Network Setup.
4
Once installed, start the PageScope Network Setup utility. (Click start,
select Program, KONICA MINOLTA, PageScope Network Setup then
PageScope Network Setup)