Konica Minolta bizhub C300 - Manual (Page 21)

2 Administrator Operations
2-2 C300
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2 Administrator Operations
2.1 Accessing the Administrator Setting Mode
This machine implements authentication of the user of the Administrator Set-
ting mode function through the 8-digit Administrator Password that verifies
the identity as the Administrator of the person who accesses the function.
During the authentication procedure, the Administrator Password entered for
the authentication purpose appears as “*” or “
●” on the display.
When the Enhanced Security mode is set to [ON], the number of times in
which authentication fails is counted.
2.1.1 Accessing the Administrator Setting mode
The machine does not accept access to the Administrator Setting mode un-
der any of the following conditions. Wait for some while before attempting to
gain access to the Administrator Setting mode again.
-
The Administrator Setting mode has been logged on to through access
made from the PC.
- A remote operation is being performed from an application on the PC.
- There is a job being executed by the machine.
- There is a reserved job (timer TX, fax redial waiting, etc.) in the machine.
- Immediately after the main power switch has been turned ON.
- A malfunction code is displayed on the machine.
2
Note
Make sure that none of the general users of the machine will know the
Administrator Password.
If the Administrator Password is forgotten, it must be set again by the
Service Engineer. Contact your Service Representative.
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
While you are logging onto the Administrator Setting mode using Page-
Scope Web Connection, any operations from the machine’s control pan-
el are disabled.
c300_security_E.book 2 ページ ２００７年４月１１日 水曜日 午前１０時４２分