Konica Minolta bizhub C451 User Manual

Page 190

Administrator mode

C451

3-81

Reminder

In order to apply the changes to the settings for items which are marked
with an asterisk (*), restart the machine (turn it off, then on again).

When the machine is turned off, then on again, turn the machine off with
the sub power switch before turning off the main power switch. In addi-
tion, wait at least 10 seconds to turn the machine on after turning it off;
otherwise, the machine may not operate correctly.

When using this machine under the IPv6 environment, there are the following
restrictions.
-

Printing using SMB is not available (available for direct hosting service).

Item

Description

TCP/IP*

Select whether or not TCP/IP is used.

Network Speed

Select the operating speed.

IP Address Setting Meth-
od*

Select whether the IP address is automatically acquired or is direct-
ly entered. If it is automatically acquired, select the check boxes to
specify the acquisition conditions.

IP Address

Specify the IP address of the machine. (Format: ***.***.***.***; Range
for ***: 0 to 255)

Subnet Mask

Specify the subnet mask of the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)

Default Gateway

Specify the default gateway for the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)

IPv6

Select whether or not IPv6 is used.
If “ON” is selected, specify settings for the following.
• Auto IPv6 Setting*
• Global Address
• Prefix Length
• Gateway Address

RAW Port Number

Select the check box for the port to be used, and then type in the
port number. (Range: 1 to 65535)

Dynamic DNS Setting

Select whether or not Dynamic DNS is enabled.

Host Name

If Dynamic DNS is enabled, type in the host name (up to 63 charac-
ters).

DNS Domain Name Set-
ting

Select whether or not the DNS domain name is automatically ac-
quired. If it is not automatically acquired, type in the domain name
below (up to 253 characters).

DNS Server Setting

A maximum of three DNS server addresses can be registered. (For-
mat: ***.***.***.***: Range for ***: 0 to 255)
If the machine is set to use IPv6, an IPv6 address can also be spec-
ified.

SLP Setting

Select whether or not SLP is enabled.

LPD Setting

Select whether or not LPD is enabled.