Konica Minolta bizhub C35 - Manual (Page 18)

bizhub C35 2-4
2.1 Accessing the Admin Settings 2
0 If an attempt is made to log on to the Admin Mode while a job is being executed, the machine gives a
message that tells that it is now impossible to log on to the Admin Mode. Click [OK] and try logging on
to the Admin Mode after the execution of the job is completed.
0 Do not leave the machine with the Admin Mode setting screen left shown on the display. If it is abso-
lutely necessary to leave the machine, be sure first to log off from the Admin Mode.
1
Start the Web browser.
2
Enter the IP address of the machine in the address bar.
3
Press the [Enter] key to start PageScope Web Connection.
4
Click the Administrator radio button and [Log in].
5
Enter the 8-digit Administrator Password in the password box.
% When accessing the Admin Mode using the PageScope Web Connection, enter the same Adminis-
trator Password as that for the machine.
6
Click [OK].
% If a wrong Administrator Password is entered, a message that tells that the authentication has failed
appears. Enter the correct Administrator Password.
% A failure in authentication as a result of the entry of a wrong password is counted as unauthorized
access. If the cumulative number of unauthorized accesses reaches three during operation of the
machine, the machine is set into an access lock state and prohibits any subsequent password entry
operations. To cancel the access lock state, turn off, then on, the power switch of the machine.
When the power switch is turned off, then on again, wait at least 10 seconds to turn it on after turn-
ing it off. This interval is necessary to ensure that the machine functions properly.
7
Click [Log out]. This allows you to log off from the Admin Mode.