Konica Minolta bizhub C35 - Manual (Page 16)

bizhub C35 2-2
2.1 Accessing the Admin Settings 2
2 Administrator Operations
2.1 Accessing the Admin Settings
This machine implements authentication of the user of the Admin Settings function through the 8-digit Ad-
ministrator Password that verifies the identity as the Administrator of the person who accesses the function.
During the authentication procedure, the Administrator Password entered for the authentication purpose ap-
pears as "*" or "
●" on the display. A failure in authentication as a result of the entry of a wrong password is
counted as unauthorized access.
NOTICE
Make sure that none of the general users of the machine will know the Administrator Password.
If the Administrator Password is forgotten, it must be set again by the Service Engineer. Contact your Service
Representative.
Accessing the Admin Settings
The machine does not accept access to the Admin Settings under any of the following conditions. Wait for
some while before attempting to gain access to the Admin Settings again.
- There is a job being executed by the machine.
- There is a reserved job (timer TX, fax redial waiting, etc.) in the machine.
- Immediately after the power switch has been turned ON.
- A malfunction code is displayed on the machine.
0 Do not leave the machine with the setting screen of Admin Settings left shown on the display. If it is
absolutely necessary to leave the machine, be sure first to log off from the Admin Settings.
1
Press the [Utility/Counter] key.
2
Touch [ ↓].
3
Touch [Admin Settings].