beautypg.com

Making the connection, Ethernet interface, Using dhcp – Konica Minolta bizhub C35P User Manual

Page 182: Making the connection -3, Ethernet interface -3 using dhcp -3

background image

Network Connection

6-3

Making the Connection

Ethernet Interface

An RJ45 connector can be used as the Ethernet interface for this printer.
When connecting your printer to an Ethernet network, the tasks you perform
depend on how you plan to set the printer’s IP (Internet Protocol) address.
Printers are shipped with a preset IP address, subnet mask, and gateway.

„

IP Address—A unique identifier for each device on a TCP/IP network.

„

Subnet Mask—A filter used to determine what subnet an IP address
belongs to.

„

Gateway—A node on a network that serves as an entrance to another
network.

Since the IP address for each PC and printer on your network must be
unique, you usually need to modify this preset address so it doesn’t conflict
with any other IP address or your network or any attached network. You can
do this in one of two ways. Each is explained in detail in the following sec-
tions.

„

Using DHCP

„

Setting the address manually

Using DHCP

If your network supports DHCP (Dynamic Host Configuration Protocol), the
printer’s IP address will be automatically assigned by the DHCP server when
you turn on the printer. (Refer to “Network Printing” on page 6-9 for a descrip-
tion of DHCP.)

"

If your printer is not automatically assigned an IP address, verify that
DHCP is enabled on the printer (

PRINT MENU - CONFIGURA-

TION PG

). If it is not enabled, you can enable it in the

INTERFACE

MENU - ETHERNET - TCP/IP - DHCP

menu.

1

Connect your printer to the network.
When using an Ethernet cable, plug the RJ45 connector into the Ethernet
interface port of the printer.

2

Turn on your PC and printer.