Konica Minolta KIP 600 Scanner - Manual (Page 141)

6-9 Section 6 ?” Screen
4.2 Power Save Settings
The KIP printer incorporates timers to save power and place the printer in “cold
sleep mode” to suit individual company production requirements. These timers
can be used to automatically turn off the printer when the “office is closed”, for
example overnight.
Energy Star Settings – Energy Star compliant settings require that the printer
goes to Warm Sleep after 15 minutes and into Cold Sleep after 90 minutes of
inactivity. These are the factory setting and can be achieved by selecting “Reset”.
There are two sleep mode settings to choose from, only one can be active at a
time and these are locked by default in the Services settings.
1. Warm/Cold Sleep Timers – This timer can be set to put the printer into a
warm/cold sleep mode after a predetermined period of inactivity.
2. Sleep Time – This time is used in conjunction with the computers clock
and is used to put the Printer to sleep at a pre-set time and wake the
printer back up at a pre-set time.
Locked or Unlocked in “Service”
a) If the Timers are locked they must first be unlocked in Service Menu. (by a
certified Service Technician)
b) Set the timers by pressing on the hour, minutes and AM/PM as needed.
c) If the printer is required during the “sleep” period, it will “awake”, produce
the prints and then ”fall asleep” again, 15 minutes later.
4.3 Default Mode
Sets which screen will be the default, Scan, Copy or
Job Info Mode dependent of the installation environment
requirement.