Konica Minolta bizhub C250 - Manual (Page 162)

Registering/Settings 9
Network Fax 9-13
Re
gist
er
ing/
Set
ti
ngs
Chapter 9
9.4 Registering the Program
In combination with the transmission conditions of [Scan Setting], an
address to which messages are sent frequently can be registered in
Program. With these kinds of information registered in Program, you can
invoke the address and the transmission conditions thus registered by just
pressing the Program key of [Program] and send out a message.
-
For the Program, up to 400 (001 to 400) can be registered including the
Program of other functions of this machine.
- Each Program can have a Program name.
The explanation here is given of the operation to register the Program.
!
Detail
[Address Book], [Group] and [Program] can be also registered using the
PageScope Web Connection. Using the PageScope Web Connection,
setting can be changed or addresses can be registered from a computer
connected to the network.
Refer to "PageScope Web Connection" on page 12-2 or the User’s Guide
(Network Scanner) for the method to use the PageScope Web
Connection.
Registering the Program
The procedure for registering the Program is as follows.
1
See "Displaying the Fax Registration Screen" on page 9-2, to display
the Fax Registration screen.
2
Press [Program].
– In the Utility Mode, it is also possible to enter a number displayed
in the key through the keypad for selection. In the case of
[Program], enter the "3" on the keypad.