Konica Minolta bizhub 25e - Manual (Page 69)

2-22 Specifying the network settings
Registering LDAP Servers
You can search for destination information such as the e-mail address and name from an
LDAP (Lightweight Directory Access Protocol) server.
„ Registering / Editing LDAP server
This section describes the procedure for registering an LDAP server. When editing, select
the LDAP server you want to edit in step 5, and press [Edit].
NOTE
• Up to five LDAP servers can be registered in the machine, but destinations cannot be
searched from all the servers at the same time. Only one server can be searched at a
time.
• You can also specify LDAP settings using Message Board. For details, see chapter 3,
“Setting the connection environment” in the Message Board Guide.
1
Press [Setting] on My MFP Menu screen.
If My MFP Menu screen is not displayed, press repeatedly until My MFP Menu
screen is displayed.
2
Press [Management].
If an administrator password is set, enter the password and press [Enter].
3
Press [Network Settings].
4
Press [LDAP Server Settings].
5
Press [Add].
When editing, select the LDAP server you want to edit, and press [Edit].
6
Configure the LDAP settings.
For details on the settings, see “List of LDAP settings” (page 2-23) .
7
Enter the desired value, and press [Enter].