Konica Minolta bizhub 25e - Manual (Page 119)

5-12 Specifications
„ Scanning area
The scanned area is shown below.
Letter
A4
Fax : Letter 8.4 in. (214 mm) / A4 8.2 in. (208 mm)
Copy, Scan : Letter 8.5 in. (216 mm) / A4 8.3 in. (210 mm)
Fax : 0.1 in.(2.0 mm )
Copy, Scan (Document glass):
0.0 in. (0.0 mm)
Copy, Scan (ADF):
0.1 in. (2.0 mm)
Fax : 0.1 in. (2.5 mm)
Copy, Scan : 0.0 in. (0.0 mm)
Scanned area
„ Precautions to load document
Automatic document feeder (ADF)
• Be sure any correction fluid, ink, or stamps on the document are completely dry
before loading.
• Remove all metals (staples, paper clips, etc.) before loading documents. Failure to do
so may cause a malfunction.
• Do not load the document with the document guide extended. Doing so may result
in skewed feeding.
• Do not add or remove documents while they are being scanned.
A document jam may occur.
• When scanning is complete, remove documents from the document exit tray to avoid
document jams.
Document glass
• Be sure any correction fluid, ink, or stamps on the document are completely dry
before loading.
• Be sure that the ADF is empty. If a document has been left in the ADF, the scanner
glass cannot be used.
• When you load a thick document, do not force the platen cover closed. Doing so may
cause a malfunction.
• When the cover is open or slightly open while copying, try not look at the light.
• When scanning is complete, remove documents from the document glass.