Konica Minolta BIZHUB C360 - Manual (Page 219)

bizhub C360/C280/C220 10-23
10.4 Administrator Settings (G3) 10
Closed Network RX
Specify whether to use the Closed Network RX function. To use the function, specify a password that is used
for Closed Network RX.
Press [No] to clear the entered setting and then specify a password using the keypad. (up to 4 digits)
Reference
- Closed Network RX is only available when the receiver has password transmission function.
Forward TX Setting
You can forward received documents to a preset recipient. The items that are to be configured are listed be-
low.
If two units of the Fax Kit FK-502 are installed, and [Individual Receiving Line Setup] is set to [ON] in Admin-
istrator Settings, you can select either [Fax Line 1] or [Fax Line 2] to configure settings for each line. For details
on [Individual Receiving Line Setup], refer to page 10-19.
The following items are not available if Forward TX Setting is configured.
- PC-Fax RX Settings
- TSI User Box Settings
- Memory RX Setting
Item Description
[Output Method] [Forward & Print]: Received document are forwarded and printed on this ma-
chine.
[Forward & Print (If TX Fails)]: Received documents are forwarded and, if for-
warding fails, are printed on the machine.
[Forward Dest.] Allows you to enter a fax number using up to 38 digits. It is also possible to
select it from the address book.
[Select Line] If two units of the Fax Kit FK-502 are installed, specify the line used to for-
ward received faxes.