Konica Minolta MS7000 MKII - Manual (Page 4)

SAFETY INFORMATION
P-2
• Do not modify this product, as a fire, electrical shock, or break-
down could result. If the product employs a laser, the laser beam
source could cause blindness.
• Do not attempt to remove the covers and panels which have been
fixed to the product. Some products have a high-voltage part or a
laser beam source inside that could cause an electrical shock or
blindness.
• Only use the power cord supplied in the package. If a power cord
is not supplied, only use the power cord and plug that is specified
in POWER CORD INSTRUCTION. Failure to use this cord could
result in a fire or electrical shock.
• Use the power cord supplied in the package only for this machine
and NEVER use it for any other product. Failure to observe this
precaution could result in a fire or electrical shock.
• Use only the specified power source voltage. Failure to do that
could result in a fire or electrical shock.
• Do not use a multiple outlet adapter to connect any other appli-
ances or machines. Use of a power outlet for more than the
marked current value could result in a fire or electrical shock.
Do not unplug and plug in the power cord with a wet hand, as an
electrical shock could result.
Plug the power cord all the way into the power outlet. Failure to do
this could result in a fire or electrical shock.
• Do not scratch, abrade, place a heavy object on, heat, twist, bend,
pull on, or damage the power cord. Use of a damaged power cord
(exposed core wire, broken wire, etc.) could result in a fire or
breakdown.
Should any of these conditions be found, immediately turn OFF
the power switch, unplug the power cord from the power outlet,
and then call your authorized service representative.
• Do not use an extension cord, in principle. Use of an extension
cord could cause a fire or electrical shock. Contact your autho-
rized service representative if an extension cord is required.