Konica Minolta MS7000 MKII - Manual (Page 149)

Miscellaneous 8
8-13
System Settings by the dealer
System Settings Description Selection Initial Setting
Auto reset Setting changes made to the control
panel that are not used within 60 sec-
onds of being input are automatically
cancelled and the system reverts back
to the original settings. Enabled * (200V)
Disabled * (120V)
Auto power save
ON/OFF Sets the unit to enable or disable the
Auto Power Save mode. Enabled *
Disabled
Printer Heater
OFF
(PR mode only) Turns the Printer's heater OFF if the
system is left idle for a specific period of
time.
* Priority is given to the Power Save
mode, if Power Save has been set.
Disabled
30 min. *
60 min.
Auto Projection
Lamp OFF Turns the Scanner's Projection Lamp
OFF if the system is left idle for a spec-
ified period of time.
* Priority is given to the Power Save
mode, if Power Save has been set.
Disabled *
30 min.
60 min.
Fine mode
contrast select
Applies the following functions as re-
quired:
Contrast Emphasis: applied when film
contains text that is poorly contrasted
against its background making it diffi-
cult to read.
Outline Emphasis: applied when film
contains blurred black and white imag-
es. Contrast
Emphasis *
Outlie
Emphasis
Auto Skew
Correction Retain
Determines whether or not to retain the
original (uncorrected) skew of a screen
image after the print has been made. Retained
Not retained *
Machine ID
Printing
(PR mode only)
When two scanners are connected to
one printer, this function leaves an
identification marker on the print so that
the scanner used for the job can be de-
termined after printing.
Pattern 1 Pattern 2
Paper Paper
Disabled *
Pattern 1
Pattern 2
Cycle print mode
(PR mode only) This function automatically scans the
next image following a preset period of
time (the period can be set by an autho-
rized Technical Representative). Imag-
es are set by the user onto the Carrier
Glass in between cycles. Enabled
Disabled *
Paper Size of
Paper Feeding
Tray
(PR mode only)
Determines the desired paper size and
the orientation from the Paper Feeding
Tray of the printer. Same as the setting for U4 of
the User Mode. See page 8-9.