Konica Minolta bizhub C20X - Manual (Page 284)

Solving Problems with Media Misfeeds 270
Solving Problems with Media Misfeeds
"
Frequent misfeeds in any area indicate that area should be checked,
repaired, or cleaned. Repeated misfeeds may also happen if you’re
using unsupported print media or original media.
Symptom Cause Solution
Several
sheets go
through the
machine
together. The front edges of
the media are not
even. Remove the media and even up the
front edges, then reload it.
The media is moist
from humidity. Remove the moist media and replace it
with new, dry media.
Too much static elec-
tricity is present. Do not fan transparencies.
Media mis-
feed mes-
sage stays
on. Front cover needs to
be opened and
closed again to reset
the machine. Open and close the front cover again.
Some media remains
misfed in the
machine. Check the media path again to make
sure that you have removed all of the
misfed media.
Duplex mis-
feeds. Unsupported media
(wrong size, thick-
ness, type, etc.) is
being used. Use KONICA MINOLTA-approved
media. See “Specifications” on page
106.
Also, refer to
http://printer.konicaminolta.com
for a complete list of currently
approved media.
Plain paper, recycled paper can be
autoduplexed if the media type is set
properly in the driver. See “Specifica-
tions” on page 106.
Make sure that you have not mixed
media types in the tray.
Do not duplex, envelopes, labels, letter
head, postcards, thick stock, glossy
media, or transparencies.
Media is still being
misfed. Check the media path inside the
duplex again to make sure that you
have removed all of the misfed media.