Konica Minolta bizhub C20X - Manual (Page 123)

Print Media 109
DO NOT use thick stock that is
„
Mixed with any other media in the trays (as this will cause media misfeed-
ing)
Envelope
Print on the front (address) side only. Some parts of the envelope consist of
three layers of paper—the front, back, and flap. Anything printed in these lay-
ered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Use envelopes that are
„
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
"
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
„ Approved for laser printing
„ Dry
Driver
Media Type Thick Stock 1
Thick Stock 2
Weight 91 to 210 g/m² (25 to 55.9 lb bond)
Duplexing Not supported
Capacity Tray 1 Up to 10 sheets, depending on their thick-
ness
Tray 2/3 Not supported
Orientation Face down
Driver
Media Type
Envelope
Weight 91 to 163 g/m 2 (25 to 43 lb bond)
Duplexing Not supported