Airlink EDGE/GPRS - Manual (Page 119)

PinPoint-E EDGE/GPRS - User Guide, version 2.32 113
AT Commands: PinPoint
*PPODOM=n
*PPODOMVAL=n
*PPPORT=n
*PPSNF=n
*PPSNFB=n
*PPSNFM=n
*PPSNFR=n
Enable odometer reporting.
n=0 : Disabled (default)
n=1 : Enabled
The PinPoint-E’s current odometer value. The value is in meters. Maximum value is approx-
imately 4.3 billion meters (2.5 million miles). 1 mile is approximately 1600 meters.
n=meters
Port where GPS reports are sent. See also SIP.
n=1-65535
Set or query the GPS report Store and Forward feature.
n=0 : Disabled
n=1 : Enabled (default)
Store and Forward will cause GPS reports to be stored up if the PinPoint-E goes out of net-
work coverage. Once the vehicle is in coverage the GPS reports will be sent en masse to the
server.
Store and Forward Behavior. When *PPSNF=1, the type of Store and Forward behavior is
defined by:
n=0 : Normal Store and Forward. Data is stored when the PinPoint-E is out of EDGE/GPRS coverage;
when the
PinPoint-E is in coverage, data is sent to server as soon as possible. This is the default for
PinPoint s with RAP version 1.3 or lower. PinPoint
n=1 : Data sent only when polled. Data is stored until polled using the Poll command sent by a server.
n=2 : Grouped Reports. Data is stored until the desired minimum number of reports (see *PPSNFM)
has been stored. The data is then sent to the server in groups with at least the specified number of reports.
Store and Forward Minimum Reports.
n=0-255
Specifies the minimum number of reports that must be stored before they are forwarded to the
server. The data is then sent to the server in packets that contain at least this number of
reports.
Store and Forward Reliability:
n=0 : Disabled