beautypg.com

Inner shoe weldment replacement – Alamo JD-5225 User Manual

Page 64

background image

© 2005 Alamo Group Inc.

Section 7 - 10

Switch Blade (JD-5105-5205-5225-5325-5425-5525, Asy. Man) 05/05

Figure 21

Rotor Actuator

Rotor Actuator

Retaining Pin

Rotor Actuator

Mounting Bolts

3/8" Bolts

3/8" Lockwashers

Rubber Bumper

Pad

Back Pivot

Plate

Shoe

Weldment

INNER SHOE WELDMENT REPLACEMENT

6.

If the Back Plate has been removed from the carriage arm, it will have to be reset after the

reassembly is done. See the Pitch adjustment in previous instruction (See Figure 4). The adjustment
to the cutter bar should be check and reset if required after reassembly.
7.

Before beginning the reassembly read this section as well as the section that pertains to the

component listed below. This is important that these components be assembled correctly as well as
adjusted properly. The assembly of the skid shoe weldment, replacement of the Rotor Actuator, Drive
Assembly, Cutter Bar, Skid Shoe and Drive Assembly Cover will be reinstalled by reversing the
disassembly instructions. (See Figure 10 thru 21)

Figure 22

Drive Stud Bearing Asy

Nylon Bearing

Clamp & Clamp Bolt

Knife Head Weldment

Blade Section

Knife Backing Strip

Figure 23

This manual is related to the following products: