Alamo JD-5225 - Manual (Page 26)

© 2005 Alamo Group Inc. Section 3 - 6
Switch Blade (JD-5105-5205-5225-5325- 5425-5525, Asy. Man) 05/05
radiator, air conditioning condenser ,oil cooler or
any electrical wiring, IT WILL NOT BE RE-
QUIRED. The Battery should already be re-
moved, if not see step one. The radiator has two
bolts on each side that mounts down to the bolster
cover plate (See Figure 7). There are two on each
side LH & RH. Also notice the side protection
shield is still installed on the RH side (See Figure
7), it is easier to work with these shields removed
but can be done with them left on.
5. You will need some one to help you re-
move the cover from under the radiator. Have
some one lift the radiator and other components
while the cover is removed out toward the front of
the tractor. An over head hoist / crane can be used
to lift and support radiator, air conditioning con-
denser and oil cooler, BUT EXTREME CAUTION
MUST be used not to damage the components
when lifted.
6. With the cover removed set the radiator
and components back down on the tractors bol-
ster, do not bolt them down, they will sit there fine
as the hoses will not let them fall (See Figure 8).
Note the electrical wiring that is left laying across
bolster, no electrical connections other that the
battery need to be disconnected to remove the
cover..
Upper Plate
Under Radiator
Lower Plate
Above Front Axle
Front Axle
Pivot Pin
Two
Mounting
Bolts
Figure 5
Figure 6
Upper Plate Front
Retainining Bolts
Upper Plate
Figure 7
Upper Plate Side
Retainining Bolts
Figure 8
4. Remove Tractor Upper Bolster Cover Plate. The tractor bolster upper cover will need to be
modified and will have to be removed from the tractor to perform this modification. The radiator will need
to be unbolted from the bolster BUT NOT removed from tractor. DO NOT disconnect any hoses for
Pump & Drive Shaft Installation: