Kodak DP2000 - Manual (Page 48)

User’s Guide KODAK DP2000 Digital Projector
42
Troubleshooting
Problem: Nothing on projection screen
• Make sure that the power cord is properly connected to a
fully functional AC electrical outlet. Make sure that the
power cord is also properly connected to the projector.
• If the projector is plugged into a power strip, make sure the
power strip is turned on.
• Make sure you have removed the lens cap on the projection
lens at the front of the projector.
• Make sure the lamp is switched on.
• Check the projector’s lamp to ensure that it is securely
connected in the lamp module. See “Replacing the
Projection Lamp” on page 38.
• Make sure that the cables do not have any bent pins.
Problem: Color or text not being projected
• You might need to adjust the brightness up or down until
the text is visible. Refer to “Brightness” on page 26 for
more information.
Problem: The screen resolution is not right
• Make sure the computer’s video card is set for a resolution
of no greater than 1024 x 768.
Problem: Image isn’t centered on the screen
• Move the projector to reposition the image.
• Reposition the image using the software. Refer to
“Horizontal position” on page 29 and “Vertical position”
on page 30.
• Be sure the projector is at a 90 degree angle to the screen.