Kodak DP2000 - Manual (Page 30)

User’s Guide KODAK DP2000 Digital Projector
24
Lamp on/off (keypad only)
Press the button to turn the lamp on or off. The Lamp LED
indicates the state of the lamp. A green Lamp LED indicates that you
can turn the lamp on, or the lamp is currently on. An orange LED
indicates the software is initializing or the lamp is cooling. Do not
press the button when the LED is orange.
Menu
Press to open the on-screen menus (the keypad lights green).
Press again to close the menus. When you close the menus, the
projector saves any changes you made. For more information about
the on-screen menus, see “Using the On-Screen Menus” on page 25.
Source (keypad only) or Computer and Video
(remote control only)
When you have more than one source (computer and video)
connected to the projector, select between them by pressing the
button on the keypad or the or button on the remote.
Standby
When you press , the display and audio turn off and a blank screen
is displayed for 15 minutes. You can change the amount of time the
projector stays in standby mode; see “Standby Time” on page 31 for
details.
• If you press again within 15 minutes, the projector returns
to normal operations immediately.
• If you don’t press again, the lamp turns off after 15
minutes.
• If you press again after 15 minutes, wait until the lamp
LED is green.
Volume (keypad only)
• To increase the volume, press
• To decrease the volume, press .
Volume adjustments are saved for each source that you have
connected.