Kodak DP2000 - Manual (Page 25)

19
Using the Projector
This section describes how to use and make adjustments to the
projector. It also provides a reference to the keypad and remote
control buttons and the options available from the on-screen menus.
Basic Image Adjustment
1. Make sure you have turned on your equipment in the right order
(page 17).
2. If the image doesn’t display completely, zoom the image
(page 20), adjust the height of the projector (page 20) or center
the image by adjusting its horizontal or vertical position
(page 29). Be sure the projector is at a 90 degree angle to the
screen.
3. If the image is out of focus, rotate the focus lens (page 20).
4. If the image appears to shimmer or if it has blurry vertical bars
after you have adjusted the focus, turn Auto Image (page 28) off
and then back on to reset the automatic sync and tracking. If that
doesn’t clear up the image, turn Auto Image off and adjust the
sync (page 29) and/or the tracking (page 29) manually.
5. If the colors don’t look right, check the KODAK Image Manager
settings. See “Kodak Menu” on page 35
Or
Adjust the brightness (page 26) and the tint (page 27).