Reducing red eye in your prints, Canceling printing, Reducing red eye in your prints canceling printing – Kodak G610 User Manual
Page 22
16
www.kodak.com/go/support
Printing without a computer
Reducing red eye in your prints
Your printer dock automatically detects and corrects red eye in your subjects before
you print your pictures.
■
Red-eye reduction is applied to images that were captured using the flash on your
digital camera.
■
You can set red-eye reduction default to always being on or off.
■
Printing time may slightly increase when using red-eye reduction.
■
Your printer dock may apply red-eye reduction to an area such as red-painted
fingernails, which darkens the area in your print. In this case, turn off red-eye
reduction.
To set/change the red-eye reduction default:
1 Connect the printer dock power (see
), then dock your camera (see
2 On the printer dock, press and hold
(Down button) and
(Transfer
button) at the same time for 5 seconds. (The Red Eye screen appears.)
3 Follow instructions on the camera or computer screen.
4 Press
(OK/Print button) to accept the red-eye default setting.
Canceling printing
To cancel printing, do one of the following:
■
Press Cancel.
A confirmation screen appears. Printing is cancelled when you select that you are sure
you want to cancel printing.
■
Press and hold Cancel for 2 seconds.
Printing is cancelled automatically.
NOTE: When printing is cancelled, the paper is ejected from the printer dock. If you cancel a print during
the fourth pass (clear coat), the print is ejected upon completion.