Revolabs FLX2 VoIP Advanced - Manual (Page 50)

50
iii. ‘Display Name’ is the string that is
shown at the far side when you
make outbound calls. If you do
not provide a Display Name, the
Username will be used. Please
note that your IP PBX might
override the Display name sent by
the FLX and replace it with names
configured in the PBX.
iv. ‘Username’ is the extension off the
IP PBX this phone will be reached
under
v. ‘Password’ is the password used
by the Username to logon to the
IP PBX.
vi. If any value was changed, a sixth option ‘Load
Settings’ is offered. This will reboot the FLX
Base Station, applying the changed settings.
d. Voice VLAN allows changing VLAN
settings. Highlight the ‘Mode’ field and
press Enter to switch between the three
options. ‘Auto’ will automatically determin
whether a VLAN is in place, and request
the VLAN identifier from the network.
‘Enabled’ will enable the VLAN, but
requires a VLAN identifier to be manually
set in the Voice VLAN ID menu. ‘Disabled’
means that no Voice VLAN is in use.
Language / Region
1. Browse to the Network Settings menu: Menu
Setup Advanced Setup Language/Region.
a. The Language submenu allows selecting
the dialer language from one of the six
supported languages: The options are
English, Español (Spanish), Français
(French), Deutsch (German), Italiano
(Italian), and Português (Portuguese).
Highlight the language of your choice, and
press either “Enter” or “Select” on the
Dialer to select it. Once a language is
select, the system will use that language for
all screen contents.