MSI Classic Motherboard - Manual (Page 22)

16
Software Application Guide
Winki Ⅲ
Software Application Guide
Winki Ⅲ
System Requirement
In order to run Winki III, the following hardware and is required
At least 2GB memory
DVD Drive
Important
If you are using the Intel SATA 6Gb/s or Marvell 88SE9128 chip, when you use Live
Update or HDDBackup utility under Winki III, please change IDE_Mode to AHCI_Mode
in BIOS setting.
Entering Winki III
You can enter Winki III OS from attached DVD or your USB key installed with Winki III
OS. Please follow the steps below:
Entering the Winki III from the DVD Drive
Put the attached DVD to the DVD drive.
Reboot and enter the BIOS by pressing “Delete” under POST screen.
Select to boot from DVD drive and reboot.
The Winki III boot screen appears as below.
Select “Winki, full-featured Winki” and press “Enter”.
■
■
1.
2.
3.
4.
5.
Select this option
Then, you will enter Winki. 6.