Cirrus Logic CDB61884 - Manual (Page 17)

CDB61884
DS485DB1 17
5.7 Global Control Register Screen
Figure 24 shows the Global Control Register (GCR) register screen, The GCR register screen consists of
the following registers:
– Software reset
– ID registers.
Each bit in the Global Control Register can be access by writing directly to the bit in the Global Control
Register on the top of this screen or by changing the radio buttons in one of the following windows:
– Jitter Attenuator
– JA FIFO Length
– AWG Auto Increment
– Raisen
– Coden
– Jitter Corner Freq.
The variables listed above change the corresponding bit in the Global Control Register. The Software Re-
set Register is a write only register and will clear after the write. The ID Register is a read only register.
Figure 24. Global Control Screen