WIKA CPH6200 User Manual
Page 20
Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2
GB
11221780.1.3 01/2009 GB/D/F/E
WIKA Operating Instructions Hand-Held Pressure Indicator
20
Starting logging:
By pressing
´Store/Quit´ for 2 seconds the logger operation will be
called. The display will show:
By pressing
´Store/Quit´ again the recording will be initiated.
After that the display shows ‘St.XXXX‘ for a short time whenever a
measuring is recorded. XXXX is the number of the measuring 1 ... 4000
or 10000.
If the logger memory is full, the display will show:
The recording automatically will be stopped.
If the Low-Power-Logger-function is selected („Lo.Po = on“) the device
switches itself off as soon as the memory becomes full.
Stopping the logging manually:
By pressing the
´Store/Quit´ key, recording can be manually interrupted.
The following choice then appears:
Stop
Do not stop
recording
recording
The selection can be made by key:
´Max´ and key: ´Min´.
Key
´Store/Quit´ enters the choice.
If you try to switch off the instrument during a logging cycle, you
will also be asked if you wish to stop recording. The device can only
be switched off after the recording has been stopped!
The Auto-Power-Off-function is deactivated during logging!